• Recent Forum Posts

    BobH

    Arielarts, That's probably why the top hole is...

    Arielarts,

    That's probably why the top hole is .30" from the bottom of the lower ring. The lower hole is then .375" below the upper one. The interesting bit is trying to line up the holes with the...

    BobH Today, 20:05 PM Go to last post
    southern_flyer

    Sorry everyone - probably I should have made...

    Sorry everyone - probably I should have made myself clear. This is my dual QXC and I'm being deliberately told to navigate via Cowden station, to test my navigation and planning abilities and to...

    southern_flyer Today, 19:39 PM Go to last post
    Arielarts

    Hi Bob, Never thought of expansion of the port...

    Hi Bob,

    Never thought of expansion of the port bridge. Obvious when you think about it - much hotter than the surrounding metalwork. You might have thought that it would put a point load on the...

    Arielarts Today, 18:46 PM Go to last post
    BobH

    Hello again, Further to my last post about the...

    Hello again,

    Further to my last post about the piston with holes drilled in the side. I thought it best to update you all. The customer arrived yesterday with his brand new 68mm piston for his...

    BobH Today, 18:31 PM Go to last post
    Randombloke

    If you're flying to Rochester from the South...

    If you're flying to Rochester from the South Coast keep it easy, stay to the East & South of the big TV mast near Heathfield (actually at Cross in Hand) then use Bewl Bridge reservoir to keep you out...

    Randombloke Today, 14:50 PM Go to last post
  • Recent Blog Posts

    tomshep

    2019 Update.

    The MiniMax stayed due lack of money for something bigger and the fun I was getting from it. This Winter's upgrades are nearly done. Ten more litres of tankage,, streamlined struts, a choke to help...

    06-03-19 19:10 PM