Quik Circuit diagram

[MikK]

hello all

I am looking for an circuit diagram for a quik based machine, I believe P&M have provided these in the past on a sheet of A3 paper so someone may have a copy I could have a copy.
I have a copy of the trim switch circuit diagram on an A3 sheet, which they sent with new wiring loom but it only covers the trim switch.

thanks

[Andymackk]

All the wiring diagrams are at the end:

LINK

[MikK]

All the wiring diagrams are at the end:

LINK

thanks
that not the one I need, I have a copy this one and its not as detailed as I need

but thanks again for assisting

[oldbaldyman]

In the past I have also looked for the basic quik wiring diagram and found the one that you are probably referring to above?
Should that be the case then 'magnify the image' and it goes right down to individual wire cable level (still a bit hard to follow though).
Regards
Paul

thanks
that not the one I need, I have a copy this one and its not as detailed as I need

but thanks again for assisting

[MikK]

In the past I have also looked for the basic quik wiring diagram and found the one that you are probably referring to above?
Should that be the case then 'magnify the image' and it goes right down to individual wire cable level (still a bit hard to follow though).
Regards
Paul

Paul, do you have a copy of the diagram?

[Chris Kyne]

IMG_3982.jpgCan't remember where I found it but this one makes more sense to me.

[Arielarts]

Sorry Chris, that isn't the GT series at all. I believe it's a Flash 2.

[MikK]

http://www.pmaviation.co.uk/download...ent%20Iss3.pdf

this one is quite good, the only thing is that the soleniod starter cable comes from pin 9, yet my instructors Quik has a separate cable coming from the push start!!!

[andy dixon]

All the wiring diagrams are at the end:

LINK

Looked everywhere for a wiring diagram.......cheers

[oldbaldyman]

As in other replies, the website is still functioning re graham slater and the wiring diagrams are at the back of the manuals.
They are reasonably accurate (variances with different instrument/electric trim fit etc) but you have to magnify the image and the individual cables 'come into view'.

I have rewired a quik and a quantum and the electrical system after the regulator is very basic DC + - etc.

Paul

Paul, do you have a copy of the diagram?